jeff.friend

Placing a UC560 behind a SonicWall TZ210 Firewall

Discussion created by jeff.friend on Aug 18, 2010

All,

 

I am currently in the process of switching between one phone system(Allworx 6x) to another(Cisco UC560).  My current setup places my phone system behind my TZ210.  For simplicity's sake I would like to place my UC560 behind the TZ210 also.(if the phone system is not placed behind the firewall it causes ALOT of additional problems for me since my entire infrastructure would need to change)  The problem is that when the UC560 is set in place I am able to place calls but the call will have no audio and I am unable to recieve calls.  Here is what I have done thus far:

 

  1. Placed the UC560 in the same location as the Allworx(connected to the same ports etc.)
  2. Configured the WAN IP address of the UC560 to be the internal IP address that the Allworx is currently using
  3. forwarded all ports to the UC560 that the phones may need

 

 

Some additional information

  1. I'm using a SIP trunk provided by Bandwidth.com
  2. my ISP is Comcast
  3. I am able to access the internet from the UC560
  4. I am not dropping any packets at the TZ210
  5. the ports/services that I am forwarding are(I wasn't sure what ports the UC560 may need so I forwarded all that I could think that would pertain)
    • UDP
      • 1024-1233
      • 15000-15511
      • 1235-1722
      • 16384-16393
      • 5060
      • 69
      • 2088
    • TCP
      • 1024-1233
      • 15000-15511
      • 1235-1722
      • 16384-16394
      • 5060
      • 69
      • 2088
    • Services
      • SIP
      • H323 Call Signaling
      • H323 Gatekeeper Discovery
      • H323 Gatekeeper RAS

 

Does anyone know what I could be missing?  Is there anything I can do to start to troubleshoot?

 

 

 

Thanks,

 

-Jeff

Outcomes