Is the -command parameter supported in httpios::geturl?

Version 1
    This document was generated from CDN thread

    Created by: Adolfo Arizpe on 29-01-2013 04:51:23 PM
    I'm calling:
      ::httpios::geturl "$baseURI/test.xml"  -command act_RequestResultConParams
    but the callback act_RequestResultConParams never gets executed.
    Also, where can I find information on the httpios::geturl command? The only very basic information I have is the "TCL IVR 2.0 Programming Guide".

    Subject: RE: Is the -command parameter supported in httpios::geturl?
    Replied by: Yaw-Ming Chen on 29-01-2013 10:13:29 PM
    httpios::geturl just regular Tcl command not Cisco Tcl IVR API specific .
    http://tmml.sourceforge.net/doc/tcl/http.htm
     
    The following is an example. I wonder if it has soemthing to do with those ""
    You may also trace those http message
    .....
        set myQuery "http://$atebHostBackup:8080/atebRetrieval/newMessageCount?store=$atebStore"
        ::httpios::geturl $myQuery -command doMsgCountRsp -timeout 5
    .....

    proc doMsgCountRsp {token} {


    }
     
    Adolfo Arizpe:
    I'm calling:
      ::httpios::geturl "$baseURI/test.xml"  -command act_RequestResultConParams
    but the callback act_RequestResultConParams never gets executed.
    Also, where can I find information on the httpios::geturl command? The only very basic information I have is the "TCL IVR 2.0 Programming Guide".