Not able to ping default gateway

Version 1
    This document was generated from CDN thread

    Created by: Kshitij Purwar on 06-03-2012 09:58:23 AM
    Hi,
     
    I have sre900 installed on 3945e router,with sre-v 2.0.it was working fine,but when i changed the configuartion then esxi 5.0 is not able to ping default-gateway.
     
    int gi0/1
    ip add 10.65.157.175 255.255.254.0
     
    int sm 1/0
    ip unnumbered gi 0/1
    service-module ip address 10.65.157.176 255.255.254.0
    service module ip default gateway 10.65.157.175
     
    int sm 1/1
    switchport mode trunk
     
    ip route 10.65.157.176 255.255.254.0 sm 1/0
     
    Regards
    Kshitij

    Subject: RE: New Message from Kshitij Purwar in Service Ready Engine Virtualization
    Replied by: Anurag Gurtu on 06-03-2012 11:27:04 AM
    Can you change the ip route to be



    ip route 10.65.157.176  255.255.255 sm 1/0





    Thanks



    Anurag Gurtu, CISSP

    Subject: RE: Not able to ping default gateway
    Replied by: Kshitij Purwar on 06-03-2012 11:53:17 AM
    Did it,
    but not able to ping.
    when i test management network connectivity from esx console,it canot ping its default gateway.
    Please help....

    Regards
    Kshitij

    Subject: RE: New Message from Kshitij Purwar in Service Ready Engine Virtualization
    Replied by: Anurag Gurtu on 06-03-2012 02:38:14 PM
    Can you try reloading ESXi. Did you make any change from DCUI?



    Thanks



    Anurag Gurtu, CISSP