Where can i get procedure for External Interface Configuration

Version 1
    This document was generated from CDN thread

    Created by: Bhargava Krishnamurthy on 17-08-2011 04:09:19 PM
    Hi,
     
    There is a interface on 910, but i don't see this interface from ESX.How do i make this interface work.
     
    # esxcfg-nics -l
    Name    PCI           Driver      Link Speed     Duplex MAC Address       MTU    Description                  
    vmnic0  0000:01:00.00 e1000e      Up   1000Mbps  Full   c4:71:fe:f9:55:2e 1500    82574L Gigabit Network Connection
    vmnic1  0000:02:00.00 bnx2        Up   1000Mbps  Full   64:00:f1:d3:27:c1 1500   Broadcom Corporation Broadcom NetXtreme II BCM5709 1000Base-SX
    vmnic2  0000:02:00.01 bnx2        Up   1000Mbps  Full   64:00:f1:d3:27:c0 1500   Broadcom Corporation Broadcom NetXtreme II BCM5709 1000Base-SX
     
     
    tx
    Bhargav

    Subject: RE: Where can i get procedure for External Interface Configuration
    Replied by: Raghavendra Gutty Veeranagappa on 19-08-2011 01:17:21 AM
    Hi Bhargav,

    To enable the external interface, you can either create a new vSwitch through vSphere client and assign the VM to that vSwitch or you can add the external interface to vSwitch1 (assuming you are using this vSwitch for your VMs).

    for more information you can refer installation and configuration documents in below link.

    http://developer.cisco.com/web/srev/docs

    Thanks,
    Raghavendra

    Subject: RE: Where can i get procedure for External Interface Configuration
    Replied by: Raghavendra Gutty Veeranagappa on 19-08-2011 02:21:05 AM
    Hi Bhargav,

    please check below link for instructions to create a new vSwitch through vSphere client

    http://www.cisco.com/en/US/prod/collateral/ps10265/ps11273/installation_guide_c07-640002.html#wp9000412

    Thanks,
    Raghavendra