VCTCL TCL and EEM Scripting for CCME

Version 1
    This document was generated from CDN thread

    Created by: Reza Sadiq on 05-08-2011 06:21:02 AM
     
    <pre>Hi I am working on a project for a Cisco Customer, developing integration between CCME and an external IP based device.  </pre>
    <pre>The CCME will need to find out the available bandwidth, and update its configuration(mainly dial peer codecs), to provide the correct telephony and video service. 
    Also we want to show on the IP Phone, the statement high/medium/low bandwidth on the its display.I am not very familiar with TCL scripting and EEM </pre>
    <pre>and would like some assistance in developing the best method to automate a telnet session from CCME (repeating every 5 seconds) to run a set of command line </pre>
    <pre>steps on the remote AXP router, find out and collect the available bandwidth value, store this and comeback to CCME, to execute a config change for dial pear codecs and </pre>
    <pre>system message output on the IP Phone display.</pre>

    Any advise and assitance is greately appreciated
    Reza
    <pre>
    </pre>

    Subject: RE: VCTCL TCL and EEM Scripting for CCME
    Replied by: Yaw-Ming Chen on 05-08-2011 11:34:40 AM
    For EEM script please use the following forum

    http://forums.cisco.com/eforum/servlet/EEM?page=main

    Subject: RE: VCTCL TCL and EEM Scripting for CCME
    Replied by: Raghavendra Gutty Veeranagappa on 05-08-2011 08:12:32 AM
    Hi Reza,

    this forum is to discuss about TCL-IVR queries, may be you can post your query in some other forums.

    Thanks,
    Raghavendra