Working TCL Script on GW-to-GW

Version 1
    This document was generated from CDN thread

    Created by: ISNET ISNET on 22-12-2010 08:14:33 AM
    Hello DevTeam,
     
    I have a project , I want to authenticate and authorize calls come from gw based on the ip address of gw via radius. My gw is Cisco2811. I need a tcl script in below.
    I dont use gatekeeper. I only use radius.I need a tcl script in below. Have you this tcl ?
     
     
    app_remote_authenticate.tcl
     
    or
     
    app_remote_ip_authenticate.2.0.0.tcl
     
     
    Best Regards.
     
    Salim Sisman

    Subject: RE: Working TCL Script on GW-to-GW
    Replied by: Anusha Kannappan on 22-12-2010 08:41:01 AM
    Hi Salim Sisman,
     
    You can have a look into the following script and modify accordingly,
     
    Here the Authentication is done with the card number and Authorization is done with the destination number
     
    http://www.cisco.com/cgi-bin/Software/Tablebuild/doftp.pl?ftpfile=cisco/access/tclware/app-debitcard-nlp.2.0.1.7.zip&app=Tablebuild&status=showC2A
     
    Thanks,
    Anusha

    Subject: RE: Working TCL Script on GW-to-GW
    Replied by: ISNET ISNET on 22-12-2010 09:13:18 AM
    Hi Salim Sisman,
     
    You can have a look into the following script and modify accordingly,
     
    Here the Authentication is done with the card number and Authorization is done with the destination number
     
    http://www.cisco.com/cgi-bin/Software/Tablebuild/doftp.pl?ftpfile=cisco/access/tclware/app-debitcard-nlp.2.0.1.7.zip&app=Tablebuild&status=showC2A
     
    Thanks,
    Anusha


    Thank you Anusha.
    Best Regards.