is it possible to set session target via TCL

Version 1

    Subject: RE: is it possible to set session target via TCL
    Replied by: Raghavendra Gutty Veeranagappa on 07-10-2010 10:14:33 AM
    Hi Deniz Aydin,
     
    it is not possible to set outbound dial-peer's session target through TCL, but you can get dial-peer information of a dial-peer item using following command
     
    object get dial-peer dp_handle3 matchTarget
     
    Thanks,
    Raghavendra
    This document was generated from CDN thread

    Created by: Deniz AYDIN on 07-10-2010 08:09:36 AM
    Hi,
    is there a way to set the outbound dial-peer's session target (the ipv4 address) in the TCL?