CUCM 6.1(1) Database Dictionary - fields in EndUser table.

Version 1
    This document was generated from CDN thread

    Created by: Mayank Sharma on 21-10-2008 02:32:28 PM
    I have a question about Cisco Unified Communications Manager 6.1(1) Database Dictionary.

    I am trying to figure out how some of the fields in the "enduser" table are populated using the CUCM Administrator's Interface.

    When I click a user in CUCM Admin. Interface, I can only see these fields (apart from other fields that I don't use):

    Last Name, Middle Name, First Name, Telephone Number, Department.

    When I pull the EndUser table using AXL SOAP request, I get a bunch of other fields which are empty. These fields are:

    site, building, nickname etc.

    How are these fields populated from the CUCM UI? I went thru the DataDictionary document and it says that they are from TypeFiledInfo.csv. I don't know what or where that file is.


    Thanks,

    Mayank

    Subject: Re: CUCM 6.1(1) Database Dictionary - fields in EndUser table.
    Replied by: David Staudt on 21-10-2008 03:46:38 PM
    The CM does not provide a UI for modifying these fields, they are mainly there as targets when syncing the CM user database with a corporate LDAP. So, data could appear in those fields if it was imported via sync from an LDAP where that data existed.

    Subject: Re: CUCM 6.1(1) Database Dictionary - fields in EndUser table.
    Replied by: Mayank Sharma on 21-10-2008 04:01:55 PM
    Apart from UI and LDAP, is there no way of populating these fields?

    Subject: Re: CUCM 6.1(1) Database Dictionary - fields in EndUser table.
    Replied by: Stephan Steiner on 22-10-2008 08:00:48 AM
    Have you tried AXL's executeSqlUpdate ? I didn't see any constraints in the data dictionary that would suggest that you cannot write into those fields.

    Subject: Re: CUCM 6.1(1) Database Dictionary - fields in EndUser table.
    Replied by: Mayank Sharma on 22-10-2008 02:46:39 PM
    Fabulous. That worked.
    Thanks so much.