Reloading audio prompts?

Version 1
    This document was generated from CDN thread

    Created by: Chris Bomba on 17-02-2010 06:34:45 PM
    I recorded a new recording for en_welcome.au.  I then upload that to the flash of my router and do a "call app voice load autoatt" and also "call lang voice load autoatt".  When I call into the application I still get the old recording for en_welcome.au.
     
    How do you reload that prompt?

    Subject: RE: Reloading audio prompts?
    Replied by: Yawming Chen on 17-02-2010 06:48:30 PM
    If it is configurable in application, like in BACD
     
      you can go to that application do :
     
      param welcome-prompt xxxx.au
     
    If hardcoded in the script then you may want to reload the application

    Subject: RE: Reloading audio prompts?
    Replied by: Aleksey Alekseev on 24-05-2010 04:09:21 PM
    to reload the file
     
    KDAR-VGW#audio-prompt load ?
      WORD  audio-prompt load name

    Subject: RE: Reloading audio prompts?
    Replied by: Yawming Chen on 24-05-2010 05:20:19 PM
    If you configure it form IOS
     
    do something like
      no param welcome-prompt xxxx.au
    and 
    param welcome-prompt xxxx.au
     
    from service will do it

    Subject: RE: Reloading audio prompts?
    Replied by: paolo bevilacqua on 10-06-2010 01:20:13 AM
    If you configure it form IOS
     
    do something like
      no param welcome-prompt xxxx.au
    and 
    param welcome-prompt xxxx.au
     
    from service will do it


    Incorrect, audio prompts must be reloaded as indicated by another poster above.
    Otherwise router will reuse cached prompts, no matter how may times you reconfigure the script.